This post is more than 5 years old
30 Posts
0
2381
can a distributed volume temporarly be split?
Hi there,
the idea is to suspend the synchronization of the distributed volume, have one site still in production and run some test's on the leg of the second site. After the testing has been completted the synchronization can be resumed and all data from the production site is mirrored to the second site.
As this can be done when using storage mirroring (e.g. SRDF or MiirrorView).
thx and kind regards
Tom
MikeCram
15 Posts
0
December 16th, 2015 11:00
While we don't have the mechanism to do what you are asking to do, I recommend using array snapshot or clone capabilities on the mirror leg to perform this operation. Please make sure that the devices have been mapped 1:1 to the volume provisioned from the array.
Follow normal best practices for fracturing a clone or creating a snap to ensure a clean application consistent copy.
vPert
30 Posts
0
December 17th, 2015 22:00
Thank you Mike for your answer.
rgds
Tom
echolaughmk
522 Posts
0
December 18th, 2015 05:00
Mike - in this setup could you utilize the set command in in the distributed device context to set the rebuild-allowed setting to to something like "false" in terms of just stopping the synchronization?
Admittedly I don't have a system to test this one so just spit-balling in case it was another alternative, but not 100% sure. I know we don't want to detach given the outcome that creates, but I wasn't sure about setting the rebuild-allowed option to false and if that stops the replication.
thanks!
-Keith
vPert
30 Posts
0
December 18th, 2015 07:00
Hi there,
I don’t think this will work because setting the “rebuild-allowed” to false does just interrupt currently running rebuild session.
There are no rebuild-session running during normal operation.
Tom
Von: echolaughmk
Gesendet: Freitag, 18. Dezember 2015 14:29
An: Tom Schmuki
Betreff: Re: - can a distributed volume temporarly be split?
ECN
can a distributed volume temporarly be split?
reply from echolaughmk in VPLEX - View the full discussion
echolaughmk
522 Posts
0
December 18th, 2015 08:00
Thanks for the confirmation....since the replication is ongoing all the time with a DR1, i wasn't sure if this would work but didn't have a system to try it out on. Sounds like it only works for the initial rebuild. Thanks for the info.