Pcie training error integrated raid system halted

Hello,

Try drain flea power, reseat controller and cable, check for good BOOT after.

drain flea power (shut down, disconnect power cables and Network cables, hold in power button 20 seconds with cords removed). After flea power drain, system has to set for 3 minutes for DRAC to reset without any power plugged in

Reseat controller and controller cables at this time.

Removing the Integrated Storage Controller Card page 112:

https://dell.to/3x3aw3j

Then plug in NIC and power but wait 2 minutes before power on to give DRAC time to initialize.

Update firmware: BIOS, iDRAC and Controller as soon as you can if it boots successfully.

If it does not boot; Try remove controller to see if it completes POST without error. It won't boot, this step is to see if it completes POST without error.

Do you have another controller to try in the system or another system to try this controller in?

With PCIe training error: Integrated RAID you will likely need to replace the controller or the system board. There is not much to narrow it down unless you are able to try the PERC in another system or a different PERC in this system.