This post is more than 5 years old
12 Posts
0
2302
Insufficient Resources
Hi,
I plan to perform the upgrade for one of my SAN switches from 4.2(7a) to 5.0(4d).Anyhow from the below compatibility check it seems that it will be a disruptive upgrade due to insufficient resources.
From the Cisco release notes;
If there is not enough memory in the system to load the new images, the upgrade will be made disruptive due to insufficient resources and the user will be notified in the compatibility table.
Compatibility check is done:
Module bootable Impact Install-type Reason
------ -------- -------------- ------------ ------
1 yes disruptive reset insufficient resources
My question is there any CLI to clear the insufficient resources before proceed with the upgrade?
Thanks,
Mudzaffar
healyj
141 Posts
0
December 12th, 2017 07:00
Hi there,
In our efforts to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we will set it to “answered.”
Regards,
Jim
mdani1
56 Posts
1
August 7th, 2012 14:00
Hopefully you would have got solution for the same from EMC till now. Let us know what solution was given.
Generally linecard ramdisk space should be checked before the upgrade in such cases.
From cli you can check spaces by using 'dir' comand.
cw9513pa# dir ?
> Redirect it to a file
>> Redirect it to a file in append mode
bootflash: Directory or filename
debug: Directory or filename
log: Directory or filename
modflash: Directory or filename
slot0: Directory or filename on expansion flash
usb1: Directory or filename
usb2: Directory or filename
volatile: Directory or filename
dir bootflash:
dir volatile: