跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

文章編號: 000131579

PowerStore: How to connect to the service console over SSH

摘要: Instructions to connect to the service console (service container) on PowerStoreT and PowerStoreX

本文可能採用自動翻譯。如果您對翻譯品質有任何寶貴意見，請使用此頁面底部的表單告訴我們，謝謝。

文章內容

症狀

PowerStore T and PowerStore X models use different physical ports for the management network access.

  • PowerStore T uses port labelled 6.
  • PowerStore X uses ports 0-1 (or bond) on the module labelled 1.

For ssh access using the service port instead of the management port, see PowerStore: SSH and PowerStore Manager access using the Service LAN Ports.
Note: When connecting to the service port, do not disconnect the management cables.


The ssh port used to log in to the service container is:

  • 22 - After the cluster creation is completed.
  • 26 - Before the Initial Configuration Wizard (ICW) is run.

原因

SSH access to the nodes may be required for troubleshooting.

解析度

SSH is not enabled for PowerStore appliances by default. To enable SSH access to the appliance:

  1. Go to Settings.
  2. Select SSH Management from the Security section.
  3. Select the appliance or appliances on which to enable SSH.
  4. Click ENABLE SSH. To disable SSH access, follow the same procedure, but click DISABLE SSH.


Only the user service can log in over ssh. The error below is observed if the wrong username is entered: 
No supported authentication methods available (server sent: publickey,gssapi-keyex,gssapi-with-mic)


Example:
image.png
 


The service user password is the password that you have setup during the Initial Configuration Wizard (ICW). The service password can be reset from the PowerStore Manger user interface, under Settings > Support > Service Account.

文章屬性

受影響的產品

PowerStore

上次發佈日期

19 12月 2022

版本

6

文章類型

Solution

返回頁首