Display Windows Move or Resize After Resuming from Sleep State
概要: This article provides information about 4K Displays, where the windows move or resize after the monitor resumes from Sleep state.
この記事は次に適用されます：
この記事は次には適用されません：
現象
Dell 4K Ultra HD monitor refresh rate issue
You may experience a problem with your Dell 4K Ultra HD monitor, which connects using the DisplayPort connection, where any open windows get resized and moved to the upper-left corner of the monitor after resuming from a sleep state from Windows 10, Windows 8(8.1) and Windows 7.
The issue has been identified with the following Dell monitor types:
- UP3214Q
- P2715Q
- P2415Q
Those monitors are with the maximum resolution set to 3840 x 2160 and a refresh rate of 60 Hertz. In addition, non-Dell 4K Ultra HD monitors with these specific settings and connection types experience an identical problem.
原因
For monitors like the P2415Q (and most 4 K displays), it is not possible to change the Refresh Rate from within Windows settings.
解決方法
Change monitor refresh rate
To resolve this issue, change the monitor setting refresh rate from 60 Hertz to 30 Hertz.
The refresh rates are set in the MONITOR On-Screen Display (OSD) menu:
Figure 1: Monitor OSD Menu
The OSD Menu should have options for either MultiStream Transport (MST) or DisplayPort 1.2 (DP1.2).
Setting MST options:
- Off = 60 Hz for 4 K displays
- Primary = Reserved for Daisy Chain setup (30 Hz for 4 K displays)
- Secondary = Reserved for Daisy Chain setup (30 Hz for 4 K displays)
Setting DP1.2 Options
- DP1.2 option set to Disabled: --> DP 1.1 = 30 Hz for 4 K displays
- DP1.2 option set to Enabled: --> DP 1.2 = 60 Hz For 4k displays