The Dell WD19 and WD19S series Dock are designed in three variations that all use the same dock base assembly.
The versions are:
There are five upgrade customer kit options available that allow you to modify a WD19 and WD19S series dock to a different configuration:
Once you receive your upgrade kit for your Dell (WD19 and WD19S) Dock, follow these steps to complete the dock upgrade:
Turn the Dock so that the Dell Logo is pointing down and remove the two (2) Philips head screws from the cable module assembly.
(Figure.1 Remove Screws)
Turn the Dock so that the Dell Logo is pointing up. Slide the cable assembly from the dock's base a few millimeters until it stops.
(Figure.2 Pull out the cable assembly)
Tilt the cable module up slightly.
(Figure.3 Tilt the module)
Remove the cable module from the dock's base.
(Figure.4 Remove the module)
Remove the upgrade cable module from the shipping box.
(Figure.5 Get the replacement)
Slide the new cable module down along the track on the dock's base.
(Figure.6 Fit the replacement)
Slide the new cable module onto the dock's base until it is fully seated.
(Figure.7 Seat the new module)
Turn the dock so that the Dell Logo is pointing down again.
(Figure.8 Flip the dock over)
Reinstall the two (2) Philips head screws.
(Figure.9 Replace the screws)
Where it was in the kit, reconnect the cables and the new AC adapter.