In this video we will demonstrate how to remove the M.2 2280 Solid-State Drive or SSD And install M.2 2230 SSD. Before removing the SSD Read through the safety guidelines to protect your computer from potential damage and ensure your personal safety.
For more information about safety guidelines, see the Service Manual at dell.com/support Before you begin, ensure that you create a recovery drive and back up all data.
Turn off your computer and disconnect all the attached peripherals. To get started, loosen the two captive screws that secure the side cover to the computer. Using the tab on the right-side of the cover, slide back and lift the side cover away from the chassis Now let’s remove the M.2-2280 from the slot and install M.2-2230.
Remove the single screw that secures the SSD to the system board. Slide and remove the SSD from its slot on the system board Remove the standoff screw installed in the M.2-2280 mounting hole And install into the M.2-2230 mounting hole Align the notch on the M.2-2230 with the tab on the card slot.
Now insert it at an angle into the card slot. Replace the single screw to secure the SSD to the system board Align the tabs on the side cover with the slots on the chassis.
Slide the side cover towards the front of the computer. Now, tighten the two captive screws to secure the side cover to the computer. You have now successfully removed the M.2 2280 SSD and installed the M.2 2230 Now connect all attached peripherals and turn on your computer.
For more information, see the Service Manual at dell.com/support.