新しい会話を開始

Solved!

ソリューションへ移動

3 Apprentice

 • 

1.3K メッセージ

2308

2020年9月3日 22:00

PowerSwitch S4128 SNMPに関して

現在PowerSwitch S4128F-ONを導入しているのですが、SNMP監視についてお客様のSNMPマネージャサーバとDell SAEへと2台のSNMPサーバへSNMPTrapを行うことは可能でしょうか。

その場合単純に2台分のSNMPサーバを登録するだけで問題ないのでしょうか。

Moderator

 • 

6.6K メッセージ

2020年9月6日 18:00

mawataraiさん

2台のSNMPマネージャサーバを設定するのはsnmp-server hostコマンドで可能です。

Dell EMC SmartFabric OS10 User Guide

 

Page 131

snmp-server host Usage: InformationThe local SNMP agent sends SNMP notifications, traps, and informs to SNMP managers configured ashost receivers. You can configure multiple host receivers.

3 Apprentice

 • 

1.3K メッセージ

2020年9月6日 19:00

Ayasさん

 

ご回答ありがとうございます!

SmartFabricを使わない場合でもこのユーザーガイドはOS10であれば問題ないでしょうか。

SmartFabricを使わないと使えないコマンド等もあるのか気になるところです。

 

Moderator

 • 

6.6K メッセージ

2020年9月7日 22:00

mawataraiさん

ご返信をありがとうございます。

 

SmartFabricを使わない場合でもこのユーザーガイドはOS10であれば問題ないでしょうか。

→使用可能です。

 

参考:Dell EMC SmartFabric OS10 User Guide

Page 163

Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.1.0. Also supported in SmartFabric mode starting in release 10.5.0.1.

 

またお知らせしたマニュアルnにも以下あります。

Page53

The OS10 CLI is the software interface you use to access a device running the software — from the console or through anetwork connection. The CLI is an OS10-specific command shell that runs on top of a Linux-based OS kernel. By leveragingindustry-standard tools and utilities, the CLI provides a powerful set of commands that you can use to monitor and configuredevices running OS10

 

mawataraiさんの意味を取り違えていたら申し訳ないのですが教えてください。

 

イベントは見つかりませんでした!

Top