Unsolved
This post is more than 5 years old
1 Rookie
•
118 Posts
0
2922
removing old ODM before upgrading to latest
Hi
we will upgrade pp from 5.1 to 5.3 ...and odm filesets
do we have to remove old odm definitions before upgrading them ?
as we have 2 upgrade procedure 1) that say to remove them"emc144935" and the other say no need "readme file"..so which one to use !!
Thanks in advance
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
December 23rd, 2010 10:00
the readme file for ODM 5.3.0.4 states:
pozzebom_ezequi
24 Posts
0
December 23rd, 2010 10:00
You should follow the primus.
Because the ODM is only populated with the information of the new filesets, as they are discovered, so the devices that are already recognized by the AIX, will keep the specifications of the old fileset and only new devices would assume the new specifications.
When you clean up all the disks, upgrade the ODM, you will have all devices with the new specifications.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
December 23rd, 2010 11:00
so simply upgrading ODM does not update fileset ? What does it do then ? Removing and reconfiguring devices from ODM is a lot more intrusive and i would like to avoid that if it's un-necessary.
pozzebom_ezequi
24 Posts
0
December 23rd, 2010 11:00
When you update the filesets, it does not apply to the disks that are already recognized, their specifications are already populated on the ODM.
The ODM is populated as the disks are recognized based on the filesets that are in place at the moment.
pozzebom_ezequi
24 Posts
0
December 23rd, 2010 11:00
Read me is talking about upgrade the filesets.
The primus emc144935 is talking about removing all the disks (clean up the ODM), upgrade the filesets, than recognize the disks again, so all disks will have the specifications of the new filesets.
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
December 23rd, 2010 12:00
i see. Can you give an example when one would want to go through the route mentioned in the primus versus simply upgrading ODM without messing with existing definitions. We are not changing device types (like converting STD to RDF1).
Thank you
pozzebom_ezequi
24 Posts
0
December 27th, 2010 09:00
I would say that the best practice is always follow the primus.
Lets say that you are at a version of ODM supported, but you are going to upgrade it.
If you don't clean the actual devices and add new devices, you would have devices recognized with two different filesets, so they can have specifications slightly different.
There some situations that it will be mandatory follow the primus, remove all the devices and reconfig them again with the new filesets.
Imagine that certain version PP requieres a new version of ODM, if do not remove the actual devices, they will keep the specifications of the old filesets even after the upgrade of them.
So following the primus is the only way to populate the ODM with the new filesets specifications and be sure that all EMC devices are running the with the same specifications.