iDRAC Settings: CBL0004: Backplane 1 connector A1 is incorrectly connectedtO BP SAS A

Hello,

Was this working and now it does not?

If so was there anything done on the system around the time the issue started?

Was the server opened? Any work done inside like adding or removing any components?

The error indicates:

CBL0004

Detailed Description:

The cable identified in the message is incorrectly connected to the backplane connector.

Recommended Response Action :

Make sure the cable identified in the message is cabled correctly.

I may first recommend a flea power drain and reseat any components and cables .

Look for any bent pins or damaged connectors or cables.

Flea power drain:

drain flea power (shut down, disconnect power cables and Network cables, hold in power button 20 seconds with cords removed).

After flea power drain, system has to set for 3 minutes for DRAC to reset without any power plugged in.

At this time Reseat any components and cables.

Then plug in NIC and power but wait 2 minutes before power on to give DRAC time to initialize.

Check results.

For the message: UEFI0116: One or more boot drivers have reported issue(s).

Check the Driver Health Menu in the Boot Manager for details.

Press F11 to enter Boot Manager. There should be an input box you can type the letter: Y and apply. Check results.