1 Rookie
•
2 Posts
0
25
what is this System Board BATT PG sensor?
Hi community,
I'm looking for information on a sensor in the PowerEdge 650 server with iDRAC9 that monitors the voltage of the CMOS battery. I noticed a sensor called "System Board BATT PG" in the Voltage sensor type section but haven't been able to find detailed documentation about it.
If anyone has documentation regarding this sensor and its thresholds, I'd greatly appreciate it.
Thanks in advance!
DELL-Joey C
Moderator
Moderator
•
3.2K Posts
0
June 27th, 2024 08:41
Hi,
Unfortuantely there is no documentation about iDRAC 9 Voltage information on System Board BATT PG threshold or range. I also did try looking through RACADM command for range, page 58: https://dell.to/4ckB9Qm but it also doesn't have any range. Perhaps, raising a case with support is needed to check with engineering if you need the information.
cpg314
1 Rookie
1 Rookie
•
2 Posts
0
June 28th, 2024 08:26
@DELL-Joey C
Thanks Joey for the reply, we will raise a support case in that case.