dell poweredge r750

Set a warning threshold for the inlet temperature
You can modify the minimum and maximum warning thresholds for the temperature sensor at the entrance of the system board. If you perform the reset to default operation, the temperature threshold is set to the default value. You must have
Configure User permission to set the warning threshold of the inlet temperature sensor.
Set the inlet temperature warning threshold on the webui
To configure the inlet temperature warning threshold, do the following:
1. On the iDRAC Web interface, go to System > Overview > Cooling > Temperature Overview.
The Temperature overview page appears.
2. In the temperature detector section, enter the minimum and maximum warning thresholds in degrees Celsius or Fahrenheit in the intake temperature of the system plate. If you enter the degree Celsius value, the system will automatically
Calculates and displays Fahrenheit values. Similarly, if you enter a Fahrenheit value, the system will also display a Celsius value.
3. Click Apply.
The value is configured.

The solution is not this, thank you for the response