Unsolved
This post is more than 5 years old
5 Posts
0
2318
Dell R910 QPI Path Operating at Half Width
I attempted to update the CPU's in my R910 last night from the current 4x Intel X7560 to 4x E7-4870 CPU's. when I installed the CPU's I received the "QPI Operating in Half Width" error between CPU 1 and 4. I swapped CPU's from 1 to 3 and then the error changed and said the QPI connection had failed between 3 and 4. My thought was that maybe there were some bent pins in socket 4, so I checked the pins with my phone and the camera zoom feature and they all appeared to be fine. When I placed the old CPU's back in the system they worked fine as well. So do I possibly have a bad CPU?
bstilts
5 Posts
0
May 1st, 2017 06:00
My service tag information is below.
Service Tag: ((Removed by Moderator))
bstilts
5 Posts
0
May 1st, 2017 09:00
Thanks for the response, I'll check the CPU's in pairs and report back. No, there has been no change in the memory configuration.
DELL-Chris H
Moderator
Moderator
•
8.6K Posts
0
May 1st, 2017 09:00
You can test the processors in pairs. Take the server to
•Two Processors
and
•Two DDR3 RDIMMs in Slots 1 and 2 of Memory Riser_A
Test each processor in successive pairs to see if one is failed.
Has there been any change in the memory?
bstilts
5 Posts
0
May 1st, 2017 11:00
I had an extra test R910 which I was able to place these CPU's into. It looks like taking it down to two CPU's I was able to determine which CPU was bad. Now I just have to find a replacement. Thanks for your help and pointing me in the right direction.
bstilts
5 Posts
0
May 1st, 2017 11:00
I was so afraid that I had bent a pin in one of the sockets previously. I spent a couple hours pouring over every socket on the board.