show ip dhcp global configuration

This command exists in the User’s Configuration Guide Version 6.7.0 page 1184

show ip dhcp global configuration
Verify the global DHCP server configuration

The following is from a console run:

Machine Description............... Dell EMC Networking Switch
System Model ID................... N2024
Machine Type...................... Dell EMC Networking N2024
Serial Number..................... xxxxxxxxxxxxxxxxxxxxxxx
Manufacturer...................... 0xbc00
Burned In MAC Address............. xxxx.xxxx.xxxx
System Object ID.................. 1.3.6.1.4.1.674.10895.3053
SOC Version....................... BCM56342_A0
HW Version........................ 5
CPLD Version...................... 20
Image File........................ N2000Stdv6.7.1.22
Software Capability............... Stack Limit = 8, VLAN Limit = 4093

unit active      backup      current-active next-active
---- ----------- ----------- -------------- --------------
1    6.7.1.22    6.7.1.22    6.7.1.22       6.7.1.22

Switch253>show ip dhcp global configuration
                       ^
% Invalid input detected at '^' marker.

Switch253>show ip dhcp ?

pool                     Display DHCP Pool Configuration parameters.
relay                    Display Bootstrap Protocol/Dynamic Host Configuration
                         Protocol Relay parameters.
snooping                 Display DHCP snooping configuration.

Switch253>

Is there an alternative command for the following:

show ip dhcp global configuration

I am trying to debug by DHCP configuration.  The WEBGUI looks good on this example.

Thanks