1 Rookie
•
1 Message
0
1629
IDPA 4400 Setup
Dear Expert,
I am trying to setup new IDPA 4400, and its connect to switch with 1G and as we know the IDPA ports has 10G and "The ports link speed is Auto Negotiated". I checked the ports from BIOS it show as disconnected.
I have connect the ports 2,3,8,9 to two switches as installation guides, but its not blinking and when I tried to configure the appliance shows message “No Uplink connectivity detected on mandatory network interface cards (vmnic0 or vmnic7 and vmnic1 or vmnic6”
It is because the 10g cannot communicate with 1g? or there is any thing i have do it?
finng
1 Rookie
1 Rookie
•
12 Posts
0
November 25th, 2021 01:00
Please review this KB ( you may need to log in to see all the details)
IDPA: PowerProtect DP4400 Initial Network Configuration workflow fails with "Appliance network configuration failed" error | Dell US
As it may help
There is another resource I would recommend is
Dell EMC SolVe Online | Dell US this one you will need to sign in/up to use
George
Dell EMC | Data Protection Division
If I've helped you, please consider giving a kudos to ensure others know this helped and/or corrected the issue.
DELL - Rod K
Moderator
Moderator
•
185 Posts
0
December 1st, 2021 15:00
Normally Dell Professional Services does all needed initial Deployment work, including providing pre-deployment guidance as to the needed network environment etc.
Deployment details, including network details, can be found here (select your IDPA version and then select the Installation Guide):
https://www.dell.com/support/kbdoc/en-in/000135863/integrated-data-protection-appliance-idpa-documents
If this is useful please give KUDOS.
thanks