This post is more than 5 years old
57 Posts
0
2268
SAN Migration From Brocade to MDS
Hi Guys
I am planning to migrate an old Brocade SilkWorm (2 nos in redundant)based to new MDS switches .There is an IBM Storage(will be removed ) connected with 8 Servers 4 of them in Cluster oracle and exchange.We are planning to install the new CX4 to the new SAN and all data from the IBM Storage is to be migrated to the new CX4 box using open migrator .The plan is roughly like this
1.Install the new MDS Switch
2.Remove the Second HBA (ie from the redundant HBA) from the Brocade switch and connect it to the new MDS.
3.Connect the new clariion ports to the MDS and luns are presented to the existing servers.
4.Data migration is done using open migrator .
5.Old storage is shut down .
6.Second MDS switch is installed and the remaining connections are made through it.
Guys any body have any comments or advice .
Please Give me
Thanks in Advance
healyj
141 Posts
0
December 12th, 2017 07:00
Hi there,
In our efforts to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we will set it to “answered.”
Regards,
Jim
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
March 6th, 2011 18:00
what OS for Oracle cluster and are you using ASM ?
adin2
57 Posts
0
March 6th, 2011 22:00
The Os iw Windows 2003 32 bit and there is no ASM.
Thanks
dynamox
2 Intern
2 Intern
•
20.4K Posts
1
March 9th, 2011 11:00
your plan should work as long as everybody involved understands the risks of running with single point of failure (one HBA). Do you have extra ports on CX4 that you could connect to the brocade. That way you could zone CX4 storage through brocade, migrate the data over to CX4 LUNs and then swing the HBAs to MDS. This way you won't be running with single HBAs.