This post is more than 5 years old
2 Intern
•
134 Posts
0
917
HBA does not log into the switch
We are in the middle of a migration and moved cables from Mcdata switch to Cisco.
The HBA's log in fine in brocade but do not on cisco.
they port status changes from "initializing" state and "link failure" state.
Found this online but did not seem to help.
http://www-947.ibm.com/support/entry/portal/docdisplay?brand=5000019&lndocid=MIGR-5076991
Any other ideas??
This is an AIX 5.3 host running on CX4. Dont think the storage array will make a difference.
tonydcdi-ymiT1
70 Posts
0
April 9th, 2011 14:00
On the cisco switch check the port type - Perhaps change the port type to F-Port and see if that helps. Also cfgmgr on the AIX host can be used to rescan the bus and possibly the switch
yaribhas
2 Intern
2 Intern
•
134 Posts
0
April 9th, 2011 14:00
That did the trick.
Appreciate the timely response.
Thanks.
From: tonydcdi-ymiT1 >
Reply-To: "jive-942263718-3ucb-2-bkso@emc-developer.hosted.jivesoftware.com " >
Date: Sat, 9 Apr 2011 17:28:06 -0400
To: Karthik Bhaskar >
Subject: New message: "HBA does not log into the switch"
EMC Community Network
HBA does not log into the switch
reply from tonydcdi-ymiT1 in Infrastructure Connectivity - View the full discussion
dynamox
2 Intern
2 Intern
•
20.4K Posts
0
April 9th, 2011 17:00
please don't forget to mark thread as answered and check correct/helpful reply.
Thank you