Unsolved
This post is more than 5 years old
15 Posts
1
869
AX100 Navisphere Express not accessable
Well, to get right to the point:
Without knowing that i do sth stupid, I pulled the the top 3 (and later the fourth) disk which contained the FLARE OS. Now i cant access the navisphere express UI anymore. Even a ping wont respond.
Is there any way for me to get access again?
I dont have any FLARE OS or navisphere software available, because its just an old product from our university for a testlab.
Is there any way to get access to the software?
Otherwise work of about 4 monts will be fruitless in that case..
best regards
Jens K.
TimH
100 Posts
0
July 24th, 2015 10:00
You might have to do this:
http://www.emc.com/collateral/TechnicalDocument/docu5219.pdf
General Search:
search
Also:
Re: AX-100 Navisphere not accessible after reboot
obi89
15 Posts
0
July 25th, 2015 09:00
Thanks Tim. When I started this topic, i wasnt sure what to do. Luckily it happened that I can still access one SP.
SP B has no IP Adress thou and i cant give one after initializing the AX100.
Now i am searching for a correct serial cable especially the rj45 - db9 adapter.
Why couldnt they choose a normal pin layout :/ ..
Edit: meh, the ping works nowfor SP A , but i cant access the navisphere express UI anymore. I guess creating my own serial cable is the only solution..?
kelleg
4.5K Posts
0
July 27th, 2015 09:00
I believe the attached doc is the correct wiring diagram for the serial cable - a DB9 (host end) to RJ45 (AX end)
glen
1 Attachment
CX500 serial cable.doc