This post is more than 5 years old
3 Posts
0
24147
problem with M1000e chassis
Hi,
I'm new to Dell blades. We received a Dell M1000e blade chassis with 8 M600 blades that I'm setting up for a test environment. It has 2 of the blades installed at this moment.
When I power on the chassis the display only says: "Enclosure Management initializing..." and the the LED is blinking in orange (red?). Nothing else happens. The VGA screen does not have any output.
I wanted to use the LCD to configure an IP address for the CMC. Where and how can I see what is wrong?
fyi the chassis has 3 I/O modules:
- A1 and A2 have a passthrough Ethernet IO Module
- B1 has a M6220 Ethernet switch.
- The blades have no mezzanine cards
Thanks in advance for any help.
Kind Regards,
gert_67
3 Posts
1
June 26th, 2012 06:00
I don't seem to be able to delete this thread but it is solved. I just plugged in the power. But when I pressed the power button to turn it off and then pressed it again to turn it on the display worked.
So this question can be ignored.
If there is a moderator: please delete it!