Unsolved
This post is more than 5 years old
1 Message
0
7694
M600 Event Trap When blade changes power state
Is there a way to get the DRAC5 or the CMC to send an SNMP or IPMI Event trap when the blade's power state changes. Say if the blade is turned off or when it is turned on (More interested in when it turns on)
Brian
Kong Yang
180 Posts
0
March 27th, 2012 12:00
Hi Brian,
Here's a snippet on the DRAC5 on how to configure a platform event trap and trigger an email:
support.dell.com/.../racugc1h.htm
Hope this helps.
DELL-Corey F
9 Posts
0
May 21st, 2012 13:00
Hello Brian,
The CMC is not capable of sending IPMI events.
In regard to SNMP traps, the CMC will only send SNMP or SMTP event traps
for blades that have been removed or when a blade has gone to the critical health
state.
For a complete listing of supported SNMP alerts please see
table 12-2 starting on page 414 in the CMC 4.0 User Guide.
http://support.dell.com/support/edocs/SOFTWARE/smdrac3/cmc/cmc4_0/en/ug/pdf/cmcug_en.pdf
-Corey