This post is more than 5 years old
73 Posts
0
1288
M1000e fabrics - M6220 switches and Passthrough interfaces?
Hi All
I have an M1000e with 4 x M6220 switches available, and I also have 2 x passthrough modules available. I have 3 x M710 FH blades with fab A,B and C . I also have 5 x M905 FH Blades with only Fab A and B. Would it be ok to use the Passthrough modules in Fab B1 and B2 and the switches in Fab A and C? I realise that I will not be able to access Fab C from the M905 blades but they are for test and dev so that is not a problem.
So is it ok to mix or is that not a good thing?
Thanks
Eric
Jaxon62
73 Posts
2
July 1st, 2016 06:00
Hi All
I went ahead and mixed the modules and it works a treat for me.