文章編號: 000124563

How to Install Dell Endpoint Security Suite Enterprise for Linux

摘要: Dell Data Security Endpoint Security Suite Enterprise for Linux can be installed using these instructions.

本文可能採用自動翻譯。如果您對翻譯品質有任何寶貴意見，請使用此頁面底部的表單告訴我們，謝謝。

Note:

As of May 2022, Dell Endpoint Security Suite Enterprise has reached End of Maintenance. This product and its articles are no longer updated by Dell. For more information, reference Product Life Cycle (End of Support / End of Life) Policy for Dell Data Security. If you have any questions on alternative articles, either reach out to your sales team or contact endpointsecurity@dell.com.
Reference Endpoint Security for additional information about current products.

This article covers how to install Dell Data Security Endpoint Security Suite Enterprise for Linux.

Affected Products:

Dell Endpoint Security Suite Enterprise for Linux

Affected Versions:

v1.0.0 and later

Affected Operating Systems:

Linux

Not applicable.

The installation process for Dell Data Security Endpoint Security Suite Enterprise for Linux is handled by using command line.

Note: For more information about product system requirements, including supported versions of Linux, reference Dell Endpoint Security Suite Enterprise System Requirements.

Terminal

In Terminal, type sudo tar –xvf '/FilePathA/DellESSE.tar.gz' –C /FilePathB and then press Enter.

Extract

Note:

In the above example:
- FilePathA is the path where the tar.gz exists.
  - FilePathA example = /home/admin/Desktop/Downloads/
- FilePathB is the path where the tar.gz is being extracted to.
  - FilePathB example = /home/admin/Desktop/ESSE
Commands are case-sensitive.
The example paths may differ in your environment.