Dell Unity: Useita asemia laajennuskehyksissä näkyy viallisina (käyttäjän korjattavissa)
Summary:
Tässä artikkelissa kerrotaan uusien levyjärjestelmien vikaantuneina ilmenevien useiden asemien oireet ja ratkaisut (näin voi käydä myös, jos ristikaapelointi tapahtuu Unityn
asentamisen jälkeen)
...
Please select a product to check article relevancy
This article applies to This article does not apply toThis article is not tied to any specific product.Not all product versions are identified in this article.
Unisphere-käyttöliittymä näyttää hälytyksiä useista DAE-asemista:
Tällä hetkellä silmukoidun taustayhteyden vuoksi vain kolme laajennuskehikkoa oli kytketty, mutta se näytti kuusi koteloa.
Varantoja ei voi luoda näillä asemilla, ja jos ryhmä on jo toiminnassa, varannot ovat offline-tilassa.
Cause
Virheellinen taustakaapelointi.
Ongelmallinen yhteys: ** Kuten alla, DPE SPA:n SAS-portti 1 on liitetty LCC A -porttiin B, ei porttiin A, ja DPE SPB SAS -portti 1 on liitetty viimeisen DAE:n LCC B -porttiin B. Tämä tekee viimeisestä DAE: stä yhdistetyn 1_0: n ja 0_2: n samanaikaisesti. Mikä loi silmukan?
Resolution
Korjaa yhteys seuraavasti:
DAE 0_0 -liitännät DPE:hen:
DPE SP A SAS -portti 0
DAE 0_0 LCC A -portti A
DPE SP B SAS -portti 0
DAE 0_0 LCC B -portti A
DAE 1_0:n liittäminen DPE:hen:
DPE SP A SAS -portti 1
DAE 1_0 LCC A -portti A
DPE SP B SAS -portti 1
DAE 1_0 LCC B -portti A
DAE 0_1 -liitettävyys:
DAE 0_0 LCC A -portti B
DAE 0_1 LCC A -portti A
DAE 0_0 LCC B -portti B
DAE 0_1 LCC B -portti A
DPE - DAE 1_0
DPE - DAE 0_0 ** Muista, että ensimmäinen DPE:n SAS-porttiin 0 liitetty kotelo on 0_0, jos se on UnityXT-tuoteperhe, ja 0_1, jos se on Unity xxx/xxxF/x50 -perhe.