How to replace the single graphics card in Aurora R11

Learn how to replace the single-graphics card on your Alienware Aurora R11. This video helps to guide you through the steps for removing and installing a single-graphics card on your Alienware Aurora R11. Before removing the single-graphics card, read through the safety guidelines to protect your computer from potential damage and ensure your personal safety. Ensure that you turn off your computer and all attached peripherals. For more information about safety guidelines, see the Alienware Aurora R11 Service Manual at //www.dell.com/support.

In this video, we will demonstrate how to remove and install the single graphics card. Before removing the single graphics card, read through the safety guidelines to protect your computer from potential damage and ensure your personal safety.

For more information about safety guidelines see the Alienware Aurora Service Manual at Dell.com/support. Before you begin, ensure that you turn off your computer and disconnect all attached peripherals.

To remove the left side cover, remove the screw that secures the side-cover release latch to the chassis. Pull the side-cover release latch to release the left side cover away from the chassis.

Lift the left side panel from the chassis. Now, let’s remove the single graphics card. Lay the computer on its right side. Press the release and clip on the power-cable connectors and disconnect the power cables from the graphics card.

Slide the power-supply-unit cage release latches to the unlocked position. Lift the power-supply-unit cage and rotate the power-supply-unit cage away from the chassis. Lift to release the graphics-card bracket from the chassis.

Push the securing tab on the PCIe slot away from the graphics card. Grasp the card by its top corner, and ease it out of the slot. You have successfully removed the single graphics card. Now, let’s see how to install the single graphics card.

Place the card into the x16 slot and press down firmly until the graphics card snaps into place. Slide the tab on the graphics-card bracket into the slot on the chassis and rotate it into place.

Rotate the power-supply-unit cage towards the chassis. Slide the power-supply-unit cage release latches towards the locked position. Connect the power cables to the graphics card.

Once the single graphics card is installed install the left side cover. To install the left side cover locate the tabs on the left side cover and the slots on the chassis.

Rotate the left side cover towards the chassis until it snaps into place. Replace the screw that secures the side-cover release latch to the chassis.

The single graphics card installation process is now completed. For more information, see the Service Manual document at Dell.com/support.