This video shows how to remove the M.2 2230 solid-state drive and mounting bracket on the M.2 card slot 1 and installing a M.2 2280 solid-state drive on the Inspiron 16 7610.
Before removing the M.2 2230 solid-state drive and mounting bracket on M.2 card slot 1 and installing a M.2 2280 solid-state drive.
Read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety.
For more information about safety guidelines, see the Inspiron 16 7610 Service Manual at: Dell.com/Support Before you begin, power off the system and disconnect all the attached peripherals, Remove any micro-SD card installed in the micro-SD card slot on your computer.
To enter Service Mode, hold down the B key on the keyboard and press the power button for 3 seconds or until the Dell Logo appears on the screen.
After the ready-to-proceed message appears on the screen, press any key to proceed. The computer emits three short beeps and shuts down immediately.
To begin, loosen the two captive screws that secure the base cover to the palm-rest and keyboard assembly Then, remove the seven screws that secure the base cover to the assembly.
Using a plastic scribe, pry the base cover from the top left at the hinge, and then continue to work on the sides to open the base cover. Lift the base cover off the palm-rest and keyboard assembly.
Note that the steps that follow are applicable to M.2 2230 SSDs installed in slot 1. To remove a M.2 2230 SSD installed in slot 1, remove the screw that secures the M.2 2230 thermal shield to the system board.
Slide and lift the M.2 2230 thermal shield off the system board. lift the M.2 2230 bracket off the system board. Slide and lift the M.2 2230 SSD from the M.2 card slot on the system board.
You have successfully removed the M.2 2230 solid-state drive in M.2 card slot 1. Now, let's install the 2280 solid-state drive align the notches on the SSD with the tabs on the M.2 card slot on the system board.
Slide the M.2 2280 SSD into the M.2 card slot on the system board. Align the M.2 2280 thermal shield to the slot on the system board and slide the thermal shield into the slot Replace the screw that secures the M.2 2280 thermal shield to the system board.
Re-install the base cover by aligning and placing the base cover on the palm-rest and keyboard assembly press the edges and sides of the base cover until it snaps into place.
Tighten the two captive screws that secure the base cover to palm rest and keyboard assembly. then, replace the seven screws that secure the base cover to the assembly.
Connect the power-adapter to the computer and press on the power button to power on the computer and exit service mode. If you need more information or assistance, go to: Dell.com/Support.
