This video shows how to replace the face plate on a PowerEdge T350. Before you begin, power off the system, and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the system. For more information about safety guidelines, see the Service manual at: Dell.com/poweredgemanuals. To begin, first remove the front bezel. To do this, using the key, unlock the bezel and pull it out. Now remove the system cover.
To do this, rotate the lock on top of the system cover to unlock position. Lift the latch to disengage the cover from the system. Then lift the system cover off. Then remove the side cover, remove the three screws from the rear side of the chassis and slide the side cover towards the rear of the system. Now to remove face plate, pull out the tabs on both sides of the face plate and take it off.
To replace the face plate, insert the tabs on the face plate with the slots on the system and press the faceplate until locks into place. Now align the side cover with the slots on the system and slide the side cover towards the front of the system until firmly seated, then tighten the three screws. Replace the system cover. To do this, first place the cover into its position on the system.
Lower the latch to engage the cover into the system. Then rotate the lock on top of the system cover to lock position. Now insert the front bezel, align and insert the bezel tabs into the slots in the system. Then press the bezel until locks in place, using the key lock the bezel. You have replaced the face plate on a PowerEdge T350. If you need more information or assistance, go to dell.com/poweredgemanuals.
