Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Turn off the system.
Remove the system from the enclosure.
Install the I/O connector cover.
CAUTION: To prevent damage to the I/O connectors, ensure that you cover the connectors when you remove the system from the enclosure.
Remove the air shroud.
Remove the drive backplane.
WARNING: Allow the memory modules to cool after you power off the system. Handle the memory modules by the card edges and avoid touching the components or metallic contacts on the memory module.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.
Removing a memory module:
Locate the appropriate memory module socket.
Push the ejectors outward on both ends of the memory module socket to release the memory module from the socket.
Lift and remove the memory module from the system.
Installing a memory module:
Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or metallic contacts.
CAUTION: To prevent damage to the memory module or the memory module socket during installation, do not bend or flex the memory module. You must insert both ends of the memory module simultaneously.
Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory module in the socket.
CAUTION: Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory module evenly.
NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in only one orientation.
Press the memory module with your thumbs until the socket levers firmly click into place.
Install the drive backplane.
Install the air shroud.
Follow the procedure listed in After working inside your system.
Remove the I/O connector cover.
CAUTION: To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
Install the system into the enclosure.
Turn on the system.
To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the installed memory.
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly seated in the memory module socket.
Run the system memory test in system diagnostics.
