This video shows how to replace the stand hinges of Inspiron 24 5430 All-In-One, or Inspiron 27 7730 All-In-One. Before you begin,turn off the computer and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the computer. To begin, place your computer, display-down on a flat surface, with the stand over the end.
Now, locate the tab underneath each stand. Then, push a scribe into the tab, and release the stand from the display-assembly base. Similarly, remove the other stand. Next, place your palm on the middle of the back cover, then, pry the back cover starting from the top, to release it from the display-assembly base. Then, lift it away from the base.
Remove the screws that secure the I/O cover to the display-assembly base. Pry open the corners of the I/O cover. Then, lift it away from the base. To remove the stand hinges, Remove the screws that secure the stand hinge to the display-assembly base. Then, lift the stand hinge off the base. Similarly, remove the other stand hinge.
To install the stand hinges, align and place the stand hinge on the display-assembly base. Replace the screws the secure the stand hinge to the base. Similarly, install the other stand hinge. Align the screw holes on the I/O cover with the screw holes on the base. Then, snap the I/O cover back into place. Replace the screws that secure the I/O cover to the base.
Next, align the slots on the back cover with the slots on the computer. Then, press along the sides to snap the back cover into place. Now, insert the stand into its slot on the back of the system until it snaps into place. Similarly, install the other stand. For more information about the Inspiron 24 5430 All-In-One, or Inspiron 27 7730 All-In-One, visit Dell.com/Support.
