In this video, we will demonstrate how to replace the retractable-camera module on an Inspiron 24 5430 All In One, or Inspiron 27 7730 All In One. Before you begin, turn off the computer and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the computer. To begin, place the computer, display-down on a flat surface, with the stand over the end. Now, locate the tab underneath each stand.
Then, push a scribe into the tab, and release the stand from the display-assembly base. Similarly, remove the other stand. Next, place your palm on the middle of the back cover, then, pry the back cover starting from the top, to release it from the display-assembly base. Then, lift it away from the base. Remove the screws that secure the I/O cover, to the display-assembly base. Pry open the corners of the IO cover. Then, lift it away from the base.
Next, remove the screws that secure the system-board shield to the display-assembly base. Then, lift it away from the base. Disconnect the camera cable from its connector on the system board. Then, peel the tape that secures it to the display-assembly base. Now, remove the screws that secure the retractable-camera assembly to the display-assembly base. Then, slide it out to remove it To install the retractable-camera assembly, slide and place the retractable-camera assembly on the display-assembly base. Then, replace the screws that secure the camera to the base.
Next, connect the camera cable to the connector on the system board. Then, adhere the tape that secures the camera cable to the display-assembly base. Align the screw holes on the system-board shield with the screw holes on the display-assembly base. Then, replace the screws that secure the shield to the base. Align the screw holes on the I/O cover with the screw holes on the base. Then, snap the IO cover back in to place. Replace the screws that secure the I/O cover to the base.
Next, align the slots on the back cover with the slots on the computer. Then, press along the sides to snap the back cover into place. Now, insert the stand into its slot on the back of the computer until it snaps into place. Similarly, install the other stand. For more information about the Inspiron 24 5430 All In One or, Inspiron 27 7730 All In One, visit Dell.com/support.
