Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section:
Turn off the system, including any attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If installed, remove the front bezel.
If applicable, remove the system from the rack.
Remove the system cover.
Removing the expansion card riser:
Holding the touch points, lift the expansion card riser from the riser connector on the system board.
Installing the expansion card riser:
Align the following:
a. Guide on the expansion-card riser with the guide pin on the system board.
b. Expansion card riser latch with the slot on the chassis.
Lower the expansion card riser until the expansion card riser is firmly seated in the connector on the system board.
Close the expansion card riser latch.
After working inside your system:
Install the system cover.
If applicable, install the system into the rack.
If removed, install the front bezel.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the system, including any attached peripherals.
