Unsolved
This post is more than 5 years old
2 Posts
0
2608
SSL Error No Cipher Match When using CAC to Connect to View 6.2
Hello All-
We recently purchased a D10DP device and I'm trying to connect to our Horizon View 6.2 environment using CAC authentication. I have set up the CA for the Entrust certificate that our security server uses, however after entering my CAC pin, I get an error in the bottom right saying "Error connecting to hostname No Cipher Match". The logs say "SSL: error ERR_SSL_NO_CIPHER_MATCH!" and "SSL: enable to setup connnection, (err=-7512)". I couldn't find anywhere to check and see what SSL cipher suites are available for the device, but I hope its not something where it is not able to support the minimum required for Horizon View 6.2 clients...
My thin client is running version 8.2_015, Horizon View is 6.2.2 build 3508079. I did test with another security server that allows access via username/password and I was able to connect.
klawrence
1 Message
0
May 18th, 2017 07:00
Curious if you found what the cause was for this error ?
jrglenni
2 Posts
0
May 18th, 2017 08:00
I never did find a solution. I still have the device as a test client, so maybe if I updated the firmware and/or update View it might behave differently, but I'm not sure. We ended up going with the 5030 Zero clients, but those suffer from not being able to use CAC for BOTH pre-session authentication and in-session use.