Unsolved
This post is more than 5 years old
1 Message
0
2568
WDM 5.7.2 Cannot get/pull image from Wyse 5020 buid 0A62
After update Wyse 5020 to build 0A62 ( over WDM) cannot get image.
The client gets the task, then reboot in nomal mode and again get task.
I tried on different clients and clean instaled WDM server.
DELL-Josh Cr
Moderator
Moderator
•
8.7K Posts
0
July 26th, 2018 10:00
Hi,
Can you private message me the service tag? Did it work on older builds?
mafischl
56 Posts
1
September 13th, 2018 08:00
This is the same issue I found and reported with build 0A62 for the 7020. Suspect that updated BIOS (2.0F) would not allow Merlin to boot automatically during an imaging.
Workaround: After signaling the device to re-image using either WDM/WMS and the unit restarts. Manually invoke the Boot Options (F12) and select Merlin from the list. This will start the re-imaging process for you. It is also possible to temporarily re-order the boot order to go to Merlin before the SATA drive (just remember to reset the boot order afterwards).
Recommend using 0A38 until the issue is resolved. I did have difficulty with the BIOS not downgrading once it is updated to 2.0F.
Tracking at: https://www.dell.com/community/Wyse-Windows-10-IoT/Merlin-Non-PXE-Image-Deployment-Broken-in-0A62/m-p/5873276#M66