This post is more than 5 years old
5 Posts
0
14896
power off vnx 5200 block
hello every body, when i power off vnx 5200 according to instruction ( in the unisphere environment) after 5 minute LED of SP Fault and SP Unsafe to remove and SP Power are off. but LED of DPE Power and DPE Fault are on and the fans of systems are still working.
the question is what can i do?
can i unplug the power wires when fans are working? is it happen for all or NOT ?
thank you for your reply.
SteveK821
2 Intern
2 Intern
•
141 Posts
2
January 25th, 2017 06:00
Hi,
that status you have is normal when you shut down the VNX properly. If you go to mydocs.emc.com you can generate your own PDF on how to perform common procedures for the VNX, including power up and power down procedures. About 5 minutes after issuing the shut down command, the LEDs on the DPE should have the following status:
DPE Fault LED - ON (Amber)
DPE Power LED - ON (Blue)
SP Fault LED - OFF
Unsafe to remove LED - OFF
SP Power LED - OFF
SP Fan pack Fault LED - ON
And the fans are still spinning (at full speed, if I remember correctly the last time I performed a shut down)
If you have this state, then you can safely unplug the power cords from the DPE. The system does not power itself off automatically.
Regards,
Stephen
MousaMo
5 Posts
0
January 21st, 2017 08:00
there is no one to answer this question?
brettesinclair
2 Intern
2 Intern
•
715 Posts
0
January 23rd, 2017 03:00
Run a fresh set of SP Collects and see where it's at. Or alternatively log an SR.
Rainer_EMC
8.6K Posts
0
January 23rd, 2017 03:00
please understand that this here is a community forum
If you need a sure answer you need to engage customer Service via an SR or support chat.
MousaMo
5 Posts
0
January 24th, 2017 06:00
thank you Brett for your reply but can you give me more detail about running a fresh set of SP and log an SR?
MousaMo
5 Posts
0
January 24th, 2017 06:00
Yes of course, i understand this is a Community forum but i think there is no reason for discomfort if you don't know the answer of my question.
MousaMo
5 Posts
0
January 26th, 2017 23:00
Hello StephenKebbell
that's it, thank you very much.
thanks again.