This post is more than 5 years old
9 Posts
0
10332
Poweredge T110 II Memory issue
Hi folks. I had a broken 2gb dimm
I thougt I buy one dimm of 8GB and replace all the other dimms
8gb Crucial Ddr3 1600 Udimm Pc (PC3-12800)
CAS 11
1.35V
NON-ECC
1600 MT/S
UDIMM
I put the dimm in the slot but the server does not boot up (i tried every slots)
Is that memory wrong ? I should be ECC only ?
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
0
September 22nd, 2017 08:00
A single DIMM is not a supported configuration, but it should work. A single DIMM configuration should only be used for troubleshooting.
If you are talking about the memory module you initially linked, it will not work in any configuration.
DELL-Daniel My
Moderator
Moderator
•
6.2K Posts
0
September 21st, 2017 17:00
Hello
The system only supports ECC memory. You can find the memory population rules in the manual.
1600MHz memory will work if it is capable of down-clocking to a supported frequency.
Thanks
eldanba
9 Posts
0
September 22nd, 2017 07:00
Thanks a lot for your answer.
Is it possible to run the server with only one 8GB dimm in one slot ? Or should I buy 2x4gb ?
Im trying to run the server with 1 dimm only and it's not working
Thanks!
eldanba
9 Posts
0
September 27th, 2017 15:00
sorry. I just found out, is written on the motherboard
eldanba
9 Posts
0
September 27th, 2017 15:00
thanks again for your answer. Im trying to troubleshot the originals dimms and im getting
Correctable and UNcorrectable ECC error BANK 1 DIMM A1
I cannot find anyplace with information on which one is BANK1 and DIMM A1...
How can i identify that dimm ?
Thanks!
eldanba
9 Posts
0
September 27th, 2017 16:00
Im getting this error in all the diagnostics tests.
I have 4x2GB dimms
I tried also with 2x2GB dimms in different banks than A1 but still I get the same error.
Can I do anything to fix it ? or is a motherboard problem ?
Tried many combinations and different dimms but always saying error in A1
Any suggestions ?
Thanks!
poweredge t110 II
eldanba
9 Posts
0
September 27th, 2017 16:00
Can I put 3x2GB total 6GB to run the server... Using 3 memory slots ? Or I need to put in pairs ?
Thanks a lot
AymanIT
1 Message
0
August 25th, 2018 04:00
I HAVE the same issue correctable ECC error when test ram memory also i have an error on ESXI ram warning