This post is more than 5 years old
10 Posts
0
28244
January 26th, 2015 23:00
MXL port configuration for PS-M4110 storage array
Dear All,
I have to configure my Force10 MXL 10/40 GbE for PS-M4110 storage array. I have two PS-M4110 connected to ports 0/13 and 0/15. I have configured it in the following way.
FTOS(conf)# no dcb enable
FTOS(conf)# iscsi enable
Configuration of ports 0/13 and 0/15 (same)
FTOS(conf-if-te-0/15)#sho con
!
interface TenGigabitEthernet 0/13
no ip address
mtu 12000
portmode hybrid
switchport
flowcontrol rx on tx off
spanning-tree mstp edge-port
spanning-tree rstp edge-port
spanning-tree 0 portfast
spanning-tree pvst edge-port
iscsi profile-compellent
no shutdown
I just need to know if these settings are okay. And do I have to configure iscsi target port (3260,860) ip-address (A.B.C.D) as well? if yes, then which IP is to be given here? group-IPaddress?
0 events found
fazalerehmankha
10 Posts
0
January 27th, 2015 10:00
Thank you Daniel. I really appreciate your prompt response. I have seen this guide and configured the switch accordingly.
fazalerehmankha
10 Posts
0
January 27th, 2015 10:00
Thank you Daniel. I really appreciate your prompt response. I have now configured the switch accordingly.