1 Rookie
•
4 Posts
0
84
Dell EMC Networking OS10 Enterprise configuring MAC authentication dot1x
Greeting,
I'm trying to set up dot1x MAC based authentication on a Dell OS10 with multiple supplicant.
Thanks for your return.
1 Rookie
•
4 Posts
0
84
Greeting,
I'm trying to set up dot1x MAC based authentication on a Dell OS10 with multiple supplicant.
Thanks for your return.
Top
DELL-Erman O
Moderator
Moderator
•
2.2K Posts
1
December 27th, 2023 10:12
Hello, as I know S4100 platform switch designed to support OS10 only. dell-networking-s4100-series-spec-sheet.pdf (https://dell.to/41zNX0N)
Dell Networking OS
Dell Network Platform Switch
Networking OS9
Supportability
SmartFabric OS10
Supportability
S4048-ON
Yes
Yes
S4148-ON
NO
Yes
DELL-Charles R
Moderator
Moderator
•
3.4K Posts
1
December 19th, 2023 18:02
Hello Swan-Zou,
I think this section may help.
Allows 802.1X authentication for either a single supplicant or multiple supplicants on an interface
Page 545
https://dell.to/3GRZ1gm
dot1x host-mode multi-auth
Swan-Zou
1 Rookie
1 Rookie
•
4 Posts
0
December 26th, 2023 14:04
Hello Charles,
Here is my 802.1x setup
Dot1x Status: Enable
Port Control: AUTO
Re-Authentication: Enable
Tx Period: 120 seconds
Quiet Period: 120 seconds
Supplicant Timeout: 3 seconds
Server Timeout: 5 seconds
Re-Auth Interval: 3 seconds
Max-EAP-Req: 5
Host Mode: MULTI_AUTH
It's already configure in a multisupplicant mode but i want to do the authentication with the mac adress of my supplicant but they don't show into my NAC system.
My NAC use Radius and the radius server is configure on my switch.
Thanks for your help and quick reply.
Regards,
Swan ZOU
DELL-Chris H
Moderator
Moderator
•
8.5K Posts
1
December 26th, 2023 14:46
Swan-Zou,
If I understand your request, I don't think it is possible to do. If you are wanting ro connect to the Radius switch via MAC address that won't be possible as you can only use the IP to connect to radius.
Let me know if this helps, or if I misunderstood your request.
Swan-Zou
1 Rookie
1 Rookie
•
4 Posts
0
December 26th, 2023 16:10
Hello Chris,
No I mean I have used the ip to connect my RADIUS with the proper port I want my switch to do MAC authentication or MAB but can't find a way to do it on OS 10 so if you know any other way to do it.
Regards
Swan ZOU
DELL-Chris H
Moderator
Moderator
•
8.5K Posts
1
December 26th, 2023 16:57
With OS9 you could try using
dot1x static-mab
but with OS10 it doesn't look to be listed or supported.
Swan-Zou
1 Rookie
1 Rookie
•
4 Posts
0
December 27th, 2023 09:18
Hello Chris,
Thanks for your reply i will see to it.
But can I really downgrade my OS10 switch to an OS9 I use the following switch S4148T-on.
Regards,
Swan ZOU