Unsolved
This post is more than 5 years old
3 Posts
0
15815
Control panel cable pinout
My system is a Dimension XPS T700r (Pentium III). I am looking for the pinout of the cable that goes from the front panel (Off-on switch, power on LED, etc ) to connector J8H1 on the motherboard. Does anyone know what the pinout of this cable is?
Goonboy
2.4K Posts
0
March 28th, 2001 03:00
You might find what you need here.
"If you can't be a good example, then you'll just have to serve as a horrible warning." --Catherine Aird
DELL-Cody
2.2K Posts
0
March 28th, 2001 21:00
larrycollier
3 Posts
0
March 29th, 2001 03:00
larrycollier
3 Posts
0
March 29th, 2001 03:00
bbessler
1 Message
0
September 18th, 2001 02:00
for a dimension.
john0877
2 Posts
0
January 19th, 2003 22:00
mines a J8F2 though so the J9E1 doesnt help
if someone got the info and can post it somewhere it would be great
rustymt
292 Posts
0
January 20th, 2003 16:00
Hi bbestler, I swaped out the motherboard in my dim 4100,I eventually plan on moveing the new P4 mobo and etc.into a new ATX case and put my 4100 back together for a spare tower.,,,,,,,, Dont know what mobo you have,,,,,,,I think some earlier mod dims may be wired like my 4100 below,,,,,hope this helps![](https://ip1.i.lithium.com/3e6e66dfab14109f04c4b5786224de24f6ccf36b/687474703a2f2f666f72756d732e75732e64656c6c2e636f6d2f692f736d696c6965732f31367831365f736d696c65792d68617070792e676966)
rustymt
Dell diminsion 4100
Motherboard pin out Frount pannel cable
7 5 3 1 1<--red trace---hard dr led--
X X X X X X X X 2<--------------power led----
X X X X X X X 3<--------------hard dr led--
8 6 4 2 4<--------------power led-----
5<--------------reset sw------
Motherboard connector 6<--------------power sw------
1 hard dr led 7<--------------reset sw------
2 power led 8<--------------power sw-------
3 hard dr led \---------------------------
4 power led \---------notused---------
5 reset sw \---------" " ""------
6 power sw \------" ""-------------
7 reset sw \---" " "----------------
8 power sw \------" "-------------
\------" ""----------
(Figure 1) \-------" "------------
(Figure 2)
Ribbon cable from frount Pannel
(16 conductor)
* "USE AS A GUIDE ONLY",,,,Rewire info for my Dell dim 4100,
check your wring with an ohm/volt meter or trace out.
(Figure 1),,,,Dell motherboard to new case.
(Figure 2),,,,Dell case to new ATX motherboard.
wyo_tom
1 Message
0
May 15th, 2004 17:00
His web address has changed.
http://www.roberthancock.com/dell/fpconn.htm