This post is more than 5 years old
13 Posts
0
599
Trunk between 9513 and 9222i
We need to create a trunk/portchannel between our 9513 and a new 9222i. The 9513 is at 3.1(3a) and the 9222i is at 4.1(3a). Can this be done or do we have to downgrade th 9222i (the 9513 cannot be upgraded at this time)?
healyj
141 Posts
0
November 28th, 2017 07:00
Hi there,
In our efforts to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we set it to “answered.”
Regards,
Jim
StorageAdmin2
124 Posts
0
July 22nd, 2009 05:00
We had a similar case when we created trunk/port channel between Cisco 9222i and 9124, I was told by my EMC SE to make sure , we are on the same firmware code on both the switches, so i m sure that should be the case with you environment as well.
tonydcdi-ymiT1
70 Posts
0
August 7th, 2009 05:00