This post is more than 5 years old
10 Posts
0
1753
Enabling f-port-channel-trunk when trunking UCS FI
I need to enable port channel the FI on the UCS 6248 but I am a bit hesitant since this is on a 9513 director switch. I have read many documents about this change, but none reassure me that it is not disruptive. When I go to Enable it I get a message that reads "Admin trunk mode will be set to off for
1 - Interfaces with admin switchport mode F,FL,FX,SD,ST in admin down state
2 - Interfaces with operational switchport mode F,FL,SD,ST Continue?"
As I read this sounds fine but I wanted to know if there were any caveats in doing so.
Wes
KurtR1
4 Posts
0
November 30th, 2012 08:00
When I typed in "feature fport-channel-trunk" my switch never asked me if I wanted to continue, it just did it. I'm running 4.2.7e. It didn't disrupt anything.