Unsolved
This post is more than 5 years old
5 Practitioner
•
274.2K Posts
0
1654
Converting Brocade to Access Gateway using NPIV
Hi
I have a Brocade switch (Blade switch Brocade IBM 5470) and I need to connect it to a ED-140M.
At this moment it's like this:
san_switch62:admin> switchshow
switchName: san_switch62
switchType: 73.6
switchState: Online
switchMode: Native
switchRole: Subordinate
switchDomain: 62
switchId: fffc3e
switchWwn: 10:00:00:05:1e:dc:48:4a
zoning: ON (B_CONFIG_20111022)
switchBeacon: OFF
Area Port Media Speed State Proto
=====================================
0 0 id 4G Online F-Port 20:35:00:a0:b8:47:9d:66
1 1 cu N8 Online F-Port 2 NPIV public
2 2 cu N8 Online F-Port 2 NPIV public
3 3 cu AN No_Sync
4 4 cu AN No_Sync
5 5 cu N8 Online F-Port 1 NPIV public
6 6 cu N8 Online F-Port 2 NPIV public
7 7 cu AN No_Sync
8 8 cu N8 Online F-Port 2 NPIV public
9 9 cu N8 Online F-Port 2 NPIV public
10 10 cu AN No_Sync
11 11 cu AN No_Sync
12 12 cu AN No_Sync
13 13 cu AN No_Sync
14 14 cu 8G Online F-Port 21:00:00:24:ff:31:51:e0
15 15 id 4G No_Light
16 16 id N4 Online E-Port 10:00:00:05:1e:35:77:4e "san_switch11" (upstream)
17 17 id N8 No_Light
18 18 id N8 No_Light
19 19 id N8 No_Light
I have 6 ports that are in NPIV mode.
When I convert it to access gateway mode, how can i make it to use npiv on the ports?
Last weekend i converted some blade switches from native to ag. But once this was done, the servers that were NPIV couldn't log into the fabric anymore. Only the ones that were not npiv could join the fabric.
Is there any special config?
felipon1
96 Posts
0
September 4th, 2012 03:00
Hi,
if you convert the blade switch to AG mode, it itself becomes a NPIV device and won't allow other NPIV devs to log in; that is the reason why you weren't able to connect NPIV devs to the blade switch.
Rgds