Dell PowerEdge T560 Installation and Service Manual

Removing the intrusion switch module

Prerequisites

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system.
Remove the expansion card riser.

NOTE:Ensure that you note the routing of the cable as you remove it from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped.

Steps

Disconnect the intrusion switch cable from the connector on the rear I/O board.
Using a Phillips #1 screwdriver, loosen the screw on the intrusion switch module.
Slide the intrusion switch module out of the slot on the system.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 1. Removing the intrusion switch module

Next steps

Replace the intrusion switch module.

歡迎

歡迎來到 Dell

Dell PowerEdge T560 Installation and Service Manual

Removing the intrusion switch module

Prerequisites

Steps

Next steps

對此內容評分