Dell PowerEdge T560 Installation and Service Manual

Installing the processor

1. Place the processor in the processor tray.
   NOTE:Ensure the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
2. Place the retaining clip on top of the processor in the processor tray aligning pin 1 indicator on the processor.
   NOTE:Ensure the pin 1 indicator on the retaining clip is aligned with the pin 1 indicator on the processor before placing the retaining clip on the processor.

   NOTE:Before you install the heat sink, ensure to place the processor and retaining clip in the tray.

   

3. Align the processor with retaining clip, by using the fingers press the retaining clip on all the four sides until it clicks into place.
   NOTE: Ensure the processor is securely latched to the retaining clip.

   

4. Apply thermal grease in a quadrilateral design on the top of the processor.
   CAUTION:Applying too much thermal grease can result in excess grease coming in contact with and contaminating the processor socket.

   NOTE:The thermal grease syringe is intended for single use only. Dispose the syringe after you use it.

   

5. For new heat sink, remove the Thermal Interface Material (TIM) protective film from the base of heat sink.

   

6. Place the heat sink on the processor and press the base of the heat sink until the retaining clip locks onto the heat sink at all the four corners.
   CAUTION:To avoid damaging the fins on the heat sink, do not press down on the heat sink fins.
   NOTE:

   • Ensure latching features on retaining clip and heat sink are aligned during assembly.
   • Ensure that the pin 1 indicator on the heat sink is aligned with the pin 1 indicator on the retaining clip before placing the heat sink onto the retaining clip.