跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge T560 Installation and Service Manual

PDF

Installing the front PERC module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Disconnect all the cables connected to the front PERC module.

Steps

  1. Align the connectors and guide slots on the front PERC module with the connectors and guide pins on the drive backplane.
  2. Slide the front PERC module until the module is connected to the drive backplane.
  3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the front PERC module to the 3.5-inch drive backplane
    This image shows how to install the front PERC module to the 3.5-inch drive backplane
    Figure 2. Installing the front PERC module to the 2.5-inch drive backplane
    This image shows how to install the front PERC module to the 2.5-inch drive backplane

Next steps

  1. Connect the cables to the front PERC module.
  2. Follow the procedure listed in After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\