- Notes, cautions, and warnings
- About this document
- System overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Air shroud
- Cooling fan
- Intrusion switch module
- Drives
- Cable routing
- Drive backplane
- Rear drive cage
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Expansion card installation guidelines
- Removing the expansion card riser
- Installing the expansion card riser
- Removing an expansion card
- Installing an expansion card
- Removing an expansion card from the expansion card riser
- Installing an expansion card into the expansion card riser
- Removing an accelerator card
- Installing an accelerator card
- M.2 SSD module on BOSS-S1 adapter card
- Optional IDSDM module
- Micro SD card
- LOM riser card
- Storage controller card
- System battery
- Optional internal USB memory key
- Optional optical drive
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Known Issue
- Getting help
- Documentation resources
Dell PowerEdge R7515 Installation and Service Manual
Removing the front bezel
Prerequisites
- Follow the safety guidelines listed
in the Safety instructions.NOTE:The bezel key is part of the bezel package.
Steps
- Unlock the bezel .
- Press the release button, and remove the left end of the bezel.
- Slide the tabs on the right end of the bezel out of the slots on the chassis and remove the bezel.
Figure 1. Removing the front bezel 
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
本文章是否有幫助？請選擇。
評語中不得包含下列特殊字元：<>()\