- Notes, cautions, and warnings
- About this document
- System overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Air shroud
- Cooling fan
- Intrusion switch module
- Drives
- Cable routing
- Drive backplane
- Rear drive cage
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Expansion card installation guidelines
- Removing the expansion card riser
- Installing the expansion card riser
- Removing an expansion card
- Installing an expansion card
- Removing an expansion card from the expansion card riser
- Installing an expansion card into the expansion card riser
- Removing an accelerator card
- Installing an accelerator card
- M.2 SSD module on BOSS-S1 adapter card
- Optional IDSDM module
- Micro SD card
- LOM riser card
- Storage controller card
- System battery
- Optional internal USB memory key
- Optional optical drive
- Power supply unit
- Power interposer board
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics and indicator codes
- Known Issue
- Getting help
- Documentation resources
Dell PowerEdge R7515 Installation and Service Manual
Removing an expansion card from the expansion card riser
Prerequisites
- Follow the safety guidelines listed in the Safety instructions.
- Follow the procedure listed in the Before working inside your system.
- Disconnect any cables that are connected to the expansion card or expansion card riser.
- Remove the air shroud.
- Remove the expansion card riser.
NOTE:The procedure to remove expansion card from riser 1A, riser 2, or riser 1B is identical.
Steps
- Pull and lift to open the expansion card retention latch.
- Hold the expansion card by its edges, and pull the card from the expansion card connector on the riser.
Figure 1. Removing the expansion card from riser 1B 
Figure 2. Removing the expansion card from riser 1A 
Figure 3. Removing the expansion card from riser 2 
- Install a filler bracket if you are not replacing the expansion card.
NOTE:You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
Figure 4. Installing a filler bracket for riser 1B 
Figure 5. Installing a filler bracket for riser 1A 
Figure 6. Installing a filler bracket for riser 2 
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
本文章是否有幫助？請選擇。
評語中不得包含下列特殊字元：<>()\