Dell PowerEdge R7515 Installation and Service Manual
Removing the LOM riser card
Steps
- Using a Phillips #2 screwdriver, remove the screws that secure the LOM riser card to the system board.
- Push the retention clips to release the LOM riser card.
- Hold the LOM riser card by the edges and lift to disconnect the card from the connector on the system board.
- Slide the LOM riser card towards the front of the system to disengage the ports from the slot.
Figure 1. Removing the LOM riser card![This image shows how to remove the LOM riser card.](https://dl.dell.com/content/guides/public/Html/per7515_ism_pub/images/GUID-BB3E9B43-99A3-43C0-B93C-5A94232B3C65-low.jpg)
- Lift the LOM riser card out of the system.
- Remove the LOM riser bracket.
- Using a Phillips #2 screwdriver, remove the screw that secures the bracket to the chassis.
- Slide the bracket out of the slot on the chassis.
Figure 2. Removing the LOM riser bracket
- If the LOM riser card is not being replaced immediately, install the LOM filler bracket.
- Insert and slide the LOM filler bracket into the slot on the chassis.
- Using a Phillips #2 screwdriver, secure the LOM filler bracket to the chassis with a screw
Figure 3. Installing the LOM filler bracket
沒有符合主題的資料
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
本文章是否有幫助?請選擇。
評語中不得包含下列特殊字元:<>()\