Dell PowerEdge R7515 Installation and Service Manual

Installing the LOM riser card

1. Remove the LOM filler bracket.
   1. Using a Phillips #2 screwdriver, remove the screw that secures the bracket to the chassis.
   2. Slide the LOM filler bracket out of the slot on the chassis.

      
      

      

      
      

2. Install the LOM riser bracket.
   1. Insert and slide the LOM riser bracket into the slot on the chassis.
   2. Using a Phillips #2 screwdriver, secure the bracket to the chassis with a screw.

      
      

      

      
      

3. Slide the LOM riser card towards the rear of the system to engage the ports from the slot on the chassis.
4. Connect the LOM riser card to the connector on the system board and push the card until the blue retention clip locks in place.
5. Using a Phillips #2 screwdriver, tighten the screws to secure the LOM card riser to the system..