Dell PowerEdge R760 Installation and Service Manual

Removing the BOSS-N1 module

The removal of the BOSS-N1 module from the Riser 1 and 4 x 2.5-inch rear drive module is similar.

Pull and lift the BOSS-N1 card carrier retention latch lock to open.
Slide the BOSS-N1 card carrier out.
Figure 1. Removing the BOSS-N1 card carrier
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1 card carrier.
Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
Figure 2. Removing the M.2 NVMe SSD
Disconnect the BOSS-N1 power and signal cable from the system board.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS-N1 module on Riser 1.
Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Figure 3. Removing the BOSS-N1 module
Pull the blue tag to remove the BOSS-N1 signal cable from the BOSS-N1 module.
Remove the BOSS-N1 power cable from the BOSS-N1 module.
Figure 4. Removing the BOSS-N1 power and signal cable from the BOSS-N1 module