跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R760 Installation and Service Manual

PDF

Installing the serial COM port

The procedure to install serial COM port to Riser 3 or 4 is same.

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud or remove the GPU air shroud.
    NOTE:The serial COM port is supported only in slot 4 or slot 8 of the expansion card riser.
  4. Remove expansion card riser.
  5. If required, remove PCIe card from slot 7.

Steps

  1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
  2. Slide the serial COM port into the expansion card riser and close the latch.
    Figure 1. Installing the serial COM port
    This image shows how to Install the Serial COM port.
  3. Connect the serial COM port cable to the rear I/O board.
  4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
  5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
  6. Tighten the captive screws on the system.
    Figure 2. Connecting the serial COM port
    This image shows how to Install the Serial COM port.

Next steps

  1. Install the air shroud or install the GPU air shroud.
  2. If required, install PCIe card to slot 7.
  3. Follow the procedure listed in After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\