跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R760 Installation and Service Manual

PDF

Installing an expansion card into the expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroudor remove the GPU air shroud.
  4. Remove the expansion card riser.
  5. If installing a new expansion card, unpack it and prepare the card for installation.
    NOTE:For instructions, see the documentation accompanying the card.
CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the system warranty.

Steps

  1. Tilt the expansion card retention latch lock to open.
  2. If installed, remove the filler bracket.
    NOTE:Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
    Figure 1. Removing the filler bracket
    This image shows Removing the filler bracket.
  3. Hold the card by edges, and align the card with the connector on the riser.
  4. Insert the card firmly into the expansion card connector until seated.
  5. Close the expansion card retention latch.
  6. Push the card holder to hold the card in the riser.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 2. Installing an expansion card into the expansion card riser
    This image shows Installing an expansion card into the expansion card riser.

Next steps

  1. If applicable, connect the cables to the expansion card.
  2. Install the expansion card risers.
  3. Install the air shroudor install the GPU air shroud.
  4. Follow the procedure listed in After working inside your system.
  5. Install any device drivers required for the card as described in the documentation for the card.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\